- April 30th, 2014, 2:18 pm#4791748
Hey all,
I decided as a personal challenge and also out of the need to have a backup pack for new members, that I'd try to build a pack using mostly the foam floor tiles. I say mostly because some plastic as well as a good ol' cake pan cycloton and PVC are being used in addition to resin fittings. But overall the goal was to build a lightweight pack that was fairly inexpensive and looked good. I have more photos that I'll have to dig up from my old phone but these give you the gist of where this project is going.
The ridging on the gearbox and powercell along with the cyclotron rings, spacer plating and detailing on the bumper are craft foam.
The plan is to have solid state or very basic light movements in the pack and gun.
Stay tuned for more!
I decided as a personal challenge and also out of the need to have a backup pack for new members, that I'd try to build a pack using mostly the foam floor tiles. I say mostly because some plastic as well as a good ol' cake pan cycloton and PVC are being used in addition to resin fittings. But overall the goal was to build a lightweight pack that was fairly inexpensive and looked good. I have more photos that I'll have to dig up from my old phone but these give you the gist of where this project is going.
The ridging on the gearbox and powercell along with the cyclotron rings, spacer plating and detailing on the bumper are craft foam.
The plan is to have solid state or very basic light movements in the pack and gun.
Stay tuned for more!
Last edited by DarkSpectre on June 11th, 2014, 2:44 pm, edited 1 time in total.
alphabeta001 liked this
"So your alien had a room at the Holiday Inn Paramus?"
www.facebook.com/seoghostbusters "Serving Southeast Ohio since 2011."
www.facebook.com/seoghostbusters "Serving Southeast Ohio since 2011."