- October 9th, 2018, 2:30 pm#4909763
I give you full permission to call me names, but is the plate that goes on top over the "bargraph lights" in the print files? I went to print and don't see that.
- October 9th, 2018, 2:43 pm#4909765
I'm noticing that no one has changed out the red rods on the side. They look a lot thinner than they should be to me. Or am I wrong?
- October 9th, 2018, 6:13 pm#4909768
The red rods that come on the SH Trap are about 0.4", so yes, about a tenth of an inch smaller than what I've seen on plans.
Personally, it doesn't bother me enough to change them out, but I could see how that might bother some people. Not a difficult fix, really.
Personally, it doesn't bother me enough to change them out, but I could see how that might bother some people. Not a difficult fix, really.
- October 24th, 2018, 6:52 pm#4910230
randomZERO wrote: ↑October 10th, 2018, 5:27 pm Nevermind I figured out what I needed. Thanks again.Im so sorry. I just stopped getting emails and didnt know I had posts here.
- By MasterObiHasLab Plasma Series Neutrona Wands | Voltage Readouts??
- By pda4everAlso, sorry I can’t answer the question, but[…]
"Ghostbusters: Afterlife" Feature Talkback Thread
- By mrmichaeltThere's some fun dialogue TV-edits, a replacement[…]
- By UncannyGirlThanks The_Y33TER ! Confirmation there's no elect[…]