darkwingduck13 wrote:***update***
Ok so I have everything workin in tandem with one another, lights and sound. However I have 2 issues, first : when the fire button is pressed the bargraph doesn't change its start up pattern nor does it scroll all the way down, second: when I flick the vent switch the vent and light work but when I flick it back on the light comes on but no start up sound... Any suggestions ? Thanks in advance
As far as I know, on this board there's not an alternate animation during the firing sequence.
As far as your vent sounds, your vent switch has a three conductor wire and a two conductor wire. The two conductor wire (I think it's the short one) should be going to your wand light board. The three conductor should be connected to the sound board. Troubleshoot by powering up the sound board and shorting the pins on Sound 7 & Sound 8 to make sure the board is doing it's part (I think 7 is vent open, 8 is vent close/power up/no hum). If everything's kosher there, the problem is either wiring (swap the three wires around until it spits out the right sounds...my switch was wired different than the instructions indicated), or the switch itself (pull the heat shrink back and check the connections...my vent switch used a 4 conductor wire, so one conductor was unused, probably yellow or green).
LawnWolf wrote:Yea, is the bar graph animation suppose to change when firing? Cause mine doesn't.
Everything turns off with the main switch except the bar graph and red light. I tried switching the red light wires but to no avail. That's all i can think to do considering all the slots on the gun light board are taken and the bar graph was pre mounted.
Anyone else have these problems?
This is similar to my issue, though on mine all of the wand lights remain on. Still searching for a solution.