- November 3rd, 2023, 6:47 am#4987349
I bought the prop from the Store on November 1st (they're doing that sale of 50% off) and got one and...one LED is dead so I'll need to get another one to replace that.
I already went on ahead to make the Motor Control mod so I can control the arm's position.
Since the Rewire of the Leds is tricky and you can break the connector easily if not careful , I had in mind to make a small PCB that does it for you and I'm gonna look for the JST connector type they used so I can get the same 7-pin connectors and prototype my rewiring PCB for GB1 and GB 2 Patterns (also thinking making it one board if possible to save PCB manufacturing costs down.
Once I know the type of JST used I'll use those and make the board.
Also what else I can do to make it almost like the movie prop itself so it doesn't be like a toy and not a movie prop.
I already went on ahead to make the Motor Control mod so I can control the arm's position.
Since the Rewire of the Leds is tricky and you can break the connector easily if not careful , I had in mind to make a small PCB that does it for you and I'm gonna look for the JST connector type they used so I can get the same 7-pin connectors and prototype my rewiring PCB for GB1 and GB 2 Patterns (also thinking making it one board if possible to save PCB manufacturing costs down.
Once I know the type of JST used I'll use those and make the board.
Also what else I can do to make it almost like the movie prop itself so it doesn't be like a toy and not a movie prop.