[LeoCor Replicas]

This post may contain an affiliate link that helps support GBFans.com when you make a purchase at no additional cost to you.

Began modding my Halloween Costumes PKE, and I want to upgrade the LEDs to something more accurate than the green ones included. Will these work?

https://www.amazon.com/Transparent-Ligh ... r=1-7&th=1

[prodestrian]

I used similar LEDs when I modded mine (it was actually part of a complete rebuild of the electronics, almost nothing original remains).
Just make sure you buy the "warm white" LEDs, the standard/cool white ones won't look as good. You can also go with yellow.




Another option which Pixel Props sells, these are more accurate flat-top LEDs: https://pixelpropsstore.com/shop/3mm-flat-top-leds/

[LeoCor Replicas]

Yep, I went with the flat top ones! Hoping I can get the arms to connect more tightly than when it first arrived. There was a massive gap with the seam between the two arm halves, so I might have to widen the holes for the LEDs.

[kman]

Couldn't you just sand the rounded bit of the LED flat?

[LeoCor Replicas]

Couldn't you just sand the rounded bit of the LED flat?

Maybe, I just don't want to. XD

The flat ones are easy enough to get, and I think they just arrived. I'm gonna start work on removing the green ones, and soldering on the new ones. I also need to re-wire the connections for the right sequence.