|
THIS IS AN OLD VERSION OF THIS PAGE. TO VIEW THE NEWEST VERSION CLICK HERE
| ' |
Banjo Elbow
|
| '' |
Tubing
|
'The actual tubing used on the pack is a contenteous issue as are the sizes and lengths used. Here is a basic guideline:
5/32" Red tubing - 4 ft needed
Installed from the elbow fittings on the HGA and Cyclotron to the straight fittings below the PPD (Note: some use 1/4" tubing here), also used between the two banjo fittings on the gun tip.
1/4" Blue tubing - 2 ft needed
Installed from the injector tube to cyclotron, from the PPD to the base of the Dale RH-50 and from the top of the RH-50 to the brass elbow fitting
1/4" Red tubing- 3 ft needed
Installed on the injector to the cyclotron and the beam line to the brass elbow on the HGA
1/4" Green tubing -1 ft needed
Installed on the gun from the brass barb on the rear instrument bar to the brass barb on the rear cylinder
5/32" yellow -1 ft needed
Installed on the Sage resistor on the Ion arm to the Legris elbow on the underside of the Ion arm (Note: some use 1/4" tubing here) |
|
This page was last edited by irricanian on January 2, 2009, 3:20 pm
Link to this page: http://www.gbfans.com/equipment/proton-pack/nycoil/
|
|
 |
|
