|
THIS IS AN OLD VERSION OF THIS PAGE. TO VIEW THE NEWEST VERSION CLICK HERE
Since its inception in 1958, Nycoil has recognized the importance of Innovation. From the introduction of the original Self-Storing Air Hose over fifty years ago to the more recent development of our state of the art Poly-Matic Push-To-Connect Fittings, Nycoil has established itself as a leader in the Fluid Power and Industrial markets.' |
Banjo Elbow
|
'Two 4mm Nycoil banjo elbows are found on the Proton Gun barrel. The Nycoil style elbow is a feature of the Ghostbusters 2 pack.
Nycoil later updated the elbow to feature a flanged red insert.
The brass body remained the same. Nycoil still offers the banjo elbow today, only it is now about a 1/4'' shorter, is nickel plated and still features a flanged red insert.
Nycoil banjo elbows are also found on the Ghost Trap Pedal in Ghostbusters 2.' |
Tubing
|
'The actual tubing used on the pack is a contenteous issue as are the sizes and lengths used. Here is a basic guideline:
5/32" Red tubing - 4 ft needed
Installed from the elbow fittings on the HGA and Cyclotron to the straight fittings below the PPD (Note: some use 1/4" tubing here), also used between the two banjo fittings on the gun tip.
1/4" Blue tubing - 2 ft needed
Installed from the injector tube to cyclotron, from the PPD to the base of the Dale RH-50 and from the top of the RH-50 to the brass elbow fitting
1/4" Red tubing- 3 ft needed
Installed on the injector to the cyclotron and the beam line to the brass elbow on the HGA
1/4" Green tubing -1 ft needed
Installed on the gun from the brass barb on the rear instrument bar to the brass barb on the rear cylinder
5/32" yellow -1 ft needed
Installed on the Sage resistor on the Ion arm to the Legris elbow on the underside of the Ion arm (Note: some use 1/4" tubing here) |
|
This page was last edited by Austin on December 29, 2009, 9:52 pm
Link to this page: http://www.gbfans.com/equipment/proton-pack/nycoil/
|
|
|
|