#4948382
According to the documentation for the powecell light, toward the end is mentioned "Stand Alone Operation" in which the ribbon cable can be cut and access each wire individually.

This is what is listed for the wire configuration in the ribbon cable

1: +VBattery (7VDCto 14VDC), connectedto “Pos”Standalone useBattery Connector
2: +VBattery (7VDCto 14VDC), connectedto “Pos”Standalone useBattery Connector
3: +VBattery (7VDCto 14VDC), connectedto “Pos”Standalone useBattery Connector
4: GND, connectedto “Gnd”Standalone useBattery Connector
5: GND,connectedto “Gnd”Standalone useBattery Connector
6: GND,connectedto “Gnd”Standalone useBattery Connector
7: Pack Change(Gnd = Change), has a weak10K to 100Kpullup to +5VDC
8: Vent(Gnd = Vent), has a weak10K to 100Kpullup to +5VDC
9: Fire (Gnd = Fire), has a weak10K to 100Kpullup to +5VDC
10: PowerUp/Down(Gnd = PowerDown), has a weak 10K to 100Kpullup to +5VDC

The ones in red are the ones I plan to utilize.

My question is what would be the wiring diagram to make this work? For argument sake, #7 will go into a momentary push button switch and #9 will go to a another push button switch.

    I'd really like to see the new t-shirt unlocks t[…]

    Hey and welcome

    My Little Pony/Ghostbusters crossover done by my d[…]

    Great work identifying the RS Temperature Control […]