- June 30th, 2021, 2:31 pm#4951217
Observations:
Disappointed the labels on the Proton Gun are stickers rather than dry-rub transfers.
The clear light cover on the top of the Proton Gun, and the red one on the Rear Instrument Bar don't appear to be arcolectric neon indicators, or close approximations.
The Trigger tip is too far down the clear tube... I'm wondering if it's actually fastened in place, or just held there by friction.
As noted on GreatGalling's Pack, the P-Clamp for the ribbon cable is too small compared to the size used on the screen-used props.
The split-loom looping up into the Gear Box appears too short.
The top of the motherboard, where it backs the Gear Box is incorrectly cut. There should be a nice, almost gentle curve on the upper portion, rather than that pronounced almost-corner.
I believe the large danger label on the motherboard is in the wrong place, and that screw beside it shouldn't be there at all.
The bumper does look crooked.
To be honest, I think Anovos should've just offered a bare, unfinished "Spengler" shell. I think that would've been an easier-to-achieve ambition for them, and would've spared a lot of customers disappointment in the delays and at the "passable" quality of the construction and finishing.
Ykymf wrote: ↑June 30th, 2021, 10:13 am This thing is incredibly heavyNot helped by the wooden block method we've seen in the past.
Ykymf wrote: ↑June 30th, 2021, 10:13 amThe barrel on the wand is not great. For starters, it's a manual pull-out. After that, it's quite easy to pull it past the point that it should go. It does seem to be connected inside by a wire but the barrel does not have lights so the wire may not be electrical and instead just meant to prevent it from falling out entirely.Could it be that it has a pop mechanism, but it's failed? And the barrel doesn't have lights? I'd expect barrel lights, even if only a simple flash set-up for what they're charging for these Packs.
Observations:
Disappointed the labels on the Proton Gun are stickers rather than dry-rub transfers.
The clear light cover on the top of the Proton Gun, and the red one on the Rear Instrument Bar don't appear to be arcolectric neon indicators, or close approximations.
The Trigger tip is too far down the clear tube... I'm wondering if it's actually fastened in place, or just held there by friction.
As noted on GreatGalling's Pack, the P-Clamp for the ribbon cable is too small compared to the size used on the screen-used props.
The split-loom looping up into the Gear Box appears too short.
The top of the motherboard, where it backs the Gear Box is incorrectly cut. There should be a nice, almost gentle curve on the upper portion, rather than that pronounced almost-corner.
I believe the large danger label on the motherboard is in the wrong place, and that screw beside it shouldn't be there at all.
The bumper does look crooked.
To be honest, I think Anovos should've just offered a bare, unfinished "Spengler" shell. I think that would've been an easier-to-achieve ambition for them, and would've spared a lot of customers disappointment in the delays and at the "passable" quality of the construction and finishing.
EnderWeggen, ccv66 liked this