Page 1 of 1

How do I remove the over heating sequence on the new spirit Halloween proton pack?

Posted: September 16th, 2021, 6:15 pm
by NextG
i just got myself a spirit Halloween proton pack and i am going to mod it btw not gonna get a light kit so my question is how to remove the over heating sequence on it

Re: How do I remove the over heating sequence on the new spirit Halloween proton pack?

Posted: September 17th, 2021, 1:22 am
by Kingpin
It's got the overheat sequence? Could you post a video of that?

The sequence is going to be built into the electronics' circuit board... There isn't really a way to remove it other than to take the whole electronics rig out, and maybe substitute it for one of the rigs from one of the older Spirit Packs.

Re: How do I remove the over heating sequence on the new spirit Halloween proton pack?

Posted: September 17th, 2021, 4:22 am
by hawkbatsquadron
If you want an entire wand and electronic package from one of the old packs, I'm willing to swap mine for yours...
This is for the wand and all attached electronics seen here:
Image

Let me know.

Re: How do I remove the over heating sequence on the new spirit Halloween proton pack?

Posted: September 17th, 2021, 10:02 am
by oidoglr
If there's an overheat sequence on the 2021 Spirit Pack, then that's either something Jason @ GB News missed when he released his review video last week, or wasn't on the unit sent to him.

Re: How do I remove the over heating sequence on the new spirit Halloween proton pack?

Posted: September 17th, 2021, 4:45 pm
by Rafaed
Did you meant the overheat sequence from another light kit you are going to get?