By Javamonkey
#4958422
I found my way back here after joining the 3d printed Ghostbusters props group on FB last week. Of course the new movie coming out has rekindled the old GB props flame.

I've kept these around over the years. No idea how old they actually are, at least 10 years for sure. I got inspired to finally make them into a pack.

Image
Image
Image

Yeah, some damage to repair but nothing major. My initial thought was to make an Afterlife pack, but with the Hasbro Pulse pack (yeah I reserved one) and my first pack being a GB 1 pack, I figured I'd go with a GB2 version for the hat trick.

Here's the grand daddy:
Image
Image

Build thread!
mburkit liked this
By Javamonkey
#4962021
First step is to repair the damage. I started with the cyclotron lower.

Image

Then I added the details and realized that I put the "bump out" for the injector wires in the wrong place. Moron. Smh.

Image

So...fixed that. Added some filler to simulate the soft edges of the vac-form. Hit it with some primer. Will need to finesse the details a little with some sandpaper.

Image
mburkit liked this

    I'd really like to see the new t-shirt unlocks t[…]

    Hey and welcome

    My Little Pony/Ghostbusters crossover done by my d[…]

    Great work identifying the RS Temperature Control […]