#4962705
I'm having a fully specced out proton pack made in the UK and shipped to LA. I'm looking for a freelance prop maker who's really good at adding extra detail, doing extra weathering and doing further upgrades based on my directions. Where could I find someone that I can trust? Besides going to the local union :) This is just for a hobby project, so not for a movie, but obviously whoever I hire, I pay their rate.

Potential upgrades I have in mind: the famous switch in the top left corner, adding those welded wires that Phoebe had on the Afterlife pack, and finding a way to do the speed controlled wind up of the lights of the accelerator.

Any and all advice is welcome. Thanks in advance!

    http://i.imgur.com/1kB7fOZ.jpg

    RGB Trap hose

    I'm doing a similar restoration job. here's what I[…]

    check the build videos which will show the sequenc[…]

    sure, the code treats the cyclotron lights as 1 gr[…]