Okay, I'm going to apologize in advance because I am a complete novice and/or idiot when it comes to this stuff. The boards are different in the newer iterations of the Ghost Trap. I had to figure this out on my own at the time with plenty of trial and error.
Sorry, no decent photos I can upload and I didn't want to pop open my ghost trap again for new photos!
You will need to relocate the board. I needed to at least. Mine is located in the lower middle section of the trap, inside between the wheels.
I de soldered the light from the board and soldered wires from the LED leads, to the positions they were in on the board itself.
For the power switch....(reference xan_theGBfan's photo
https://imgur.com/a/0kYxqci) I believe I soldered a wire from the ON lead, to (1) of the board switch, and the OFF lead to the (3) of the board switch.
You may have to extend the speaker wires or replace them all together because I don't think they will reach once you relocate the board.
Like I said, this was a trial and error process for me and was also very tedious at times. Please ask me any questions so I can try and be more specific if need be. I wish I would have made a thorough post about this at the time with photo