- August 1st, 2021, 9:48 am#4953033
Pretty much everything about the uniform is now DONE, aside from painting my hose connector.
One mistake: I had Magnoli make mine to measurements. Except Mr. Fienen is getting older, and put on, like, ten pounds since I ordered. So I'm pretty tight around the chest now. I should have anticipated the fact that these should be baggy anyway, and built a couple inches into my measurements. That's on me though, not them.
- Suit from Magnoli
- Gizmo kit from EctoLabs
- MT500 3D printed from Quentin's designs: https://cults3d.com/en/3d-model/gadget/ ... rola-mt500
- Hose connector 3D printed from https://www.thingiverse.com/thing:2188222
- Belt, gloves, fobs, and elbow pads from GBFans
- Boots are Corcoran 995s from Work Boots USA
- Hose dyed per the "Unorthodox" method: viewtopic.php?f=4&t=40310
One mistake: I had Magnoli make mine to measurements. Except Mr. Fienen is getting older, and put on, like, ten pounds since I ordered. So I'm pretty tight around the chest now. I should have anticipated the fact that these should be baggy anyway, and built a couple inches into my measurements. That's on me though, not them.
- By mardin_chatzuk
- By The_Y33TER