Have a guide or tutorial? Post it up!
User avatar
By jreverhart
#4908319
This post may contain an affiliate link that helps support GBFans.com when you make a purchase at no additional cost to you.

lapena77 wrote: September 2nd, 2018, 3:12 pm What size of screws can I use to mount all electronics, I using electronics form GB fan shop
Howdy, I used these
https://www.amazon.com/gp/product/B073Z ... UTF8&psc=1

and used epoxy putty to attach the risers then used a short riser on the top. I attached all my electronics to the shell, so when i removed it I reduced the risk of yanking on the wires, and easier to line up the lights better. but its a preference but should work the same.

I've seen others just use like #6 nuts and bolts to mount aluminum plates and then use risers from there off the board. its really up to you whats easier. I tried to drill as few holes as possible in the MOBO (not including the speaker holes)
jpetrutis81 liked this

    I don't remember exactly, But I think I've had pr[…]

    Someone ID'd them on Facebook first, there w[…]

    Two specific ideas I have are basically holiday sp[…]

    While waiting impatiently for Frozen Empire to rel[…]