This is for other Ghostbusters Props that don't fit into the categories above.
By DanielVankman
#4934905
this is my belt gizmo printed in part in 3d. the circuit board is made of a plastic plate on which i have glued a printed film with the original circuit board pattern. I traced all contacts with a gold pen to achieve a 3D effect. all transistors and resistors are from an old mainboard. i also made the computer chips with the 3d printer and provided them with stickers. the glass flasks are old aquarium hoses that I cut to size. I inserted an old spring into the hose to recreate the effect of the original glow rate as much as possible. I then installed and wired a red led. the cabling for the current of the led is via the black ring cable.

Image
Image
cristovalc, twmedford23, KennyGardner and 1 others liked this

    I haven't done the new update to the Spirits Unlea[…]

    I ended up grabbing one of the 84 wands just t[…]

    Matty PKE Question...URGENT

    Depending on the price, it might be worth snatchin[…]

    I have a full sized spirit pack, and I have the gh[…]