JWils23 wrote:I just measured the GB1 set I have from Joe Luna who’s using Nickatrons old molds and the bottom are 1”, the top is actually 1 3/16”.
When you measured the top spacer did you measure the end to the curve? I made spacers out of Hockey pucks and didn't realized that the groove in the spacer sits the frame to the motherboard at 1". That extra length of rubber curves around the groove on the bar of the frame, so the frame can mount flush in the spacer. If using steel spacers I believe all three spacers should be the exact length.
So, um, tell us again how the events of all […]
We'll just hang around Ghost Corps and fact chec[…]
Think we need to start sharing the blame, I don't […]
Dan Schoening posted the textless version of the v[…]