- November 29th, 2020, 8:25 am#4942736
Hi guys, and yes I know before you say, it is blasphemous to want to do this to a pack. But I'm planning on building "My pack", taking various ideas and designs from various packs that I like and putting them all together.
One of which involves recreating a more "on purpose" version of the stantz pack powercell lights leaking out of the thin areas of the shell, which I believe the TVG pack included too.
My question is - what would be the best method to cut out the small slits I have marked out on the shell cleanly? (About 8mm×2mm)
I was thinking of a dremel but I'm not sure if there is a bit that would be able to do what I need it to in such a small precise area?
One of which involves recreating a more "on purpose" version of the stantz pack powercell lights leaking out of the thin areas of the shell, which I believe the TVG pack included too.
My question is - what would be the best method to cut out the small slits I have marked out on the shell cleanly? (About 8mm×2mm)
I was thinking of a dremel but I'm not sure if there is a bit that would be able to do what I need it to in such a small precise area?
Last edited by l3w1sb159 on January 7th, 2021, 4:48 am, edited 2 times in total.