This is for other Ghostbusters Props that don't fit into the categories above.
#4956019
Hi friends,

Been coming up with a way to create an updated, modern look at a belt Gizmo. I’ve been tinkering around with Arduino and I must say, for $27.50 worth of electronics, can’t really beat this little number!

It’s an arduino uno with an LCD shield plugged into it. Then I just used Sugru to stick it to a blank piece of circuit board that I trimmed to exactly fit in my slightly customized tape-measure belt holder.

The whole thing is powered by a 9-volt battery. The 5 buttons plus the reset put it into different modes, system checks of the proton pack, PKE meter readings, anomaly detectors… all fictional of course. Just pre-scripted sequences. Numbers animate up and down. It’s made to look like it’s always either reading out live data or sweeping the area for phenomenon.
Image
Image
Image
Image
Nighty80, SPJ liked this

    Two other questions with multiple parts: 1) si[…]

    In the process of reviving my old pack, and was lu[…]

    Grooberson can't spell. On his whiteboard he wrot[…]

    Afterlife Deleted Scenes

    9QMlH3AE55g I think I did see the earthquake[…]