User avatar
By Neutrontopofit
#4966328
Thanks again, you've been a big help!

It's too bad there isn't one master set of models but I'm starting to see how difficult would be to gather all the information. I had originally wanted to make a very comprehensive list of parts but now I think I'll settle for only the visible components. There is simply too much variation and too many small details for me to take on; If I'm not careful I'll end up trying to do a full model.
tobycj liked this
By tobycj
#4971062
RiverofSlime wrote: June 21st, 2022, 7:28 pm I've been trying to figure out which size of socket cap screw is needed for the ion arm resistors?

Thank you!
Either M3 or 4-40, depending on which are easier to get for you. They're a very similar size.
#4971067
Thanks!


I ended using some slightly too large hex caps I had on-hand. Hit the resistors with a slight nudge from the dremel and the hex caps went right in.



tobycj wrote: June 30th, 2022, 6:07 am
RiverofSlime wrote: June 21st, 2022, 7:28 pm I've been trying to figure out which size of socket cap screw is needed for the ion arm resistors?

Thank you!
Either M3 or 4-40, depending on which are easier to get for you. They're a very similar size.
tobycj liked this
By tobycj
#4971519
rkavanagh wrote: July 19th, 2022, 3:04 pm Question for everyone...right now Mack's Factory is waitlisted and GBfans doesn't have the Pack shells in stock, what is the best place to purchase a full size one currently?
I'd recommend Proton Props in the UK.
rkavanagh liked this

This thread is the reason why I starded a pack! Aw[…]

htaf5vyKwSI Alex

Tying into the fire switch will cause the rumble a[…]

There are no suits in overstock at the moment.