User avatar
By RiverofSlime
#4971585
Greetings one and all, below is my 2017 Spirit pack with 2021 Hasbro Proton Blaster. Parts are mix of 3D printed, found objects, and fan-made. Based largely on GB2 photos but not intended to be 100% a "GB2 Pack."

A pack is never done so this is where I'm at...


Image
Image
Image
Image
Image
Image
Image
Image
Image
Image
Last edited by RiverofSlime on August 22nd, 2022, 8:05 pm, edited 1 time in total.
CitizenBuster, jonogunn, twmedford23 and 1 others liked this
User avatar
By RiverofSlime
#4971680
Thank you! That's the GB Fans kit, which was a tight squeeze! I haven't wanted to open it up again since getting it all in there.

I purchased a 3D printer pretty much at the end of my build process so at some point I will probably print a different wand (and possibly a whole other full scale pack). Because I needed to bore out some of the internal parts of the blaster it didn't go back together as well as I would have liked. Specifically one of the screw posts from the top inside.

I learned a lot along the process and would definitely do it differently knowing what I do now.
Last edited by RiverofSlime on July 29th, 2022, 11:26 am, edited 1 time in total.

    Make it that pack, sell it for $599. (While I […]

    Yeah, we've been building this thing for ten[…]

    Someone on FB found it. NARDA ELECTROMAGNETIC RADI[…]

    It appears that some time today someone who […]