- February 2nd, 2023, 10:53 am#4978270
Hi there,
New to the site and got my Haslab pack recently. Haven't cracked it open yet, was waiting for wand to show up and they are both sitting in the spare room calling to be like Zuul.
I'm looking to replace the ribbon with G1 ribbon.
Has anyone been able to design new clamps for a G1 ribbon so that you don't have to use the existing Haslab connector?
I'd like to be able to just unplug the existing ribbon from both ends and replace it with a complete G1 ribbon with connectors.
This way I could put the stock ribbon back easily.
Anyone? Thoughts?
New to the site and got my Haslab pack recently. Haven't cracked it open yet, was waiting for wand to show up and they are both sitting in the spare room calling to be like Zuul.
I'm looking to replace the ribbon with G1 ribbon.
Has anyone been able to design new clamps for a G1 ribbon so that you don't have to use the existing Haslab connector?
I'd like to be able to just unplug the existing ribbon from both ends and replace it with a complete G1 ribbon with connectors.
This way I could put the stock ribbon back easily.
Anyone? Thoughts?