#4980216
Thought I'd ask here before doing some deep digging.
I had the trap finished, with pedal all working with your code. I had to adjust the door settings slight so they open and close nicely without hitting each other.
Then gave a go at adding in new part to the code so that the states went like this, similar to 'gpstar' code as his wasn't working on my board for some reason even the V2.0.
Open, just bright light
Capture, flickering
Trap, baragraph and what not
Reset.
Either way it didn't work as intended and went to go back to your original code and noticed its not triggering anything, you start it and it beeps and the baragraph lights up but then when you press side knob or short the foster connector nothing.
Any ideas?
I noticed the servo's were hot but they still kinda work if adjusting the int setup in the code
I've unplugged everything individually to see for some reason if wire had done anything though it was stationary on my bench and everything got correct Live and Earth

Thanks
Jacque

    I don't remember exactly, But I think I've had pr[…]

    Someone ID'd them on Facebook first, there w[…]

    Two specific ideas I have are basically holiday sp[…]

    While waiting impatiently for Frozen Empire to rel[…]